Clas Ohlson ER2536 - Connections and Settings; Bluetooth Connection; Operating Instructions

6
English
Operating instructions
On/off
Theproduct has two power switches, [ MAIN, ON/OFF ] (1) and [ AC, ON/OFF ] (2)
which work as follows:
[ MAIN, ON/OFF ] [ AC, ON/OFF ]
ON OFF Theproduct is switched on and powered by
thebuilt-in battery.
ON ON Theproduct is switched on and powered by
230V mains supply.
OFF ON Theproduct is switched off and thebuilt-in
battery is being charged.
OFF OFF Theproduct is switched off and thebuilt-in
battery is not being charged.
Connections and settings
For details of connections and settings, refer to theButtons and functions
sectionabove.
Bluetooth connection
To connect anexternal device via Bluetooth, do as follows:
1. Switch thespeaker to thedesired mode, refer to thetableabove.
2. Press [ Select Input ] so that theLED indicator for Bluetooth status lights (it starts to
flash after afew seconds)
3. Activate Bluetooth on thedevice to be paired with thespeaker.
4. Thespeaker will appear on your device as ER2536, select it and pair it with your
device. Referto theinstruction manual of your device for further clarification if you
are unsure.
5. Once connection has been established theLED indicator on thespeaker will shine
asteadyblue.
6. Start playback on your device. Setthedesired volume levels both on your device
and thespeaker. Control theother playback settings on theexternal device and on
thespeaker.
Note: Ifyou are prompted to enter aPIN code on your device, you should enter 0000
(four zeroes). Certain devices may also require you to approve theconnection.
If you have connected amobile phone to thespeaker via Bluetooth and receive
acall whilst you are listening to music, themusic will be switched off automatically.
Oncethecall has been ended, music playback will be resumed (if your phone settings
enable this).