Need help?Do you have a question about the Classe Audio CA-100 and is the answer not in the manual?
General| Type | Stereo Power Amplifier |
|---|---|
| Frequency Response | 20Hz - 20kHz ±0.1dB |
| Damping Factor | Greater than 200 |
| Input Sensitivity | 1.0V for rated output |
| Total Harmonic Distortion | Less than 0.005% at 1kHz, at rated power |
| Signal-to-Noise Ratio | Greater than 100dB, A-weighted |
Fine-tuning sound by parts and voltage adjustments for natural realism, mimicking live performance.
Common circuit design across models, upgraded over time for performance benefits, benefiting all units.
Use of high-quality parts ensures long-term reliability and enjoyment for owners.
Check for concealed damage and missing parts after unpacking the amplifier.
Position the amplifier allowing clearance for airflow and hum avoidance.
Details AC line fuse ratings based on operating voltage.
Connect the linecord to the AC receptacle on the rear of the unit.
Connect input/output for stereo operation, ensuring tight connections and correct phasing.
Connect for mono use, ensuring the STEREO/MONO switch is set to MONO [DOWN].
Optional connection for remote ON/OFF using a Classé Remote Interface Module.
Use RCA connectors for regular inputs, switching the selector to REGULAR [UP].
Use XLR connectors for balanced inputs, switching to BALANCED [DOWN], matching pin configurations.
Unit has rail fuses and an AC line fuse to protect drivers and the unit from shorts or DC content.
Blinking GREEN LED indicates protection trigger; turn off, identify, correct, and restart.
Lists key features like power output, chassis, inputs, and finishes.
Details frequency response, sensitivity, impedance, gain, THD+N, S/N ratio, and output ratings.
To Next Page