Classen SC-18AHD - Storage

STORAGE
Storage Instructions
WARNING
!
To prevent possible explosion or ignition of vapor-
ized fuel, do not store equipment with fuel in tank or
carburetor in enclosure with open ame (for example,
a furnace or water heater pilot light).
Daily Storage
1. Check engine oil level and air filter element daily.
2. Check oil level in engine gearbox.
3. Close fuel valve at bottom of fuel tank.
4. Clean cutting blade (grass, dirt, etc.).
Extended Storage
Before the equipment is put into storage for any
period exceeding 30 days:
1. Follow the storage instructions included in the
engine manufacturer's owner manual
2. Lubricate all lubrication fittings.
3. Clean and oil cutting blade to prevent rust.
To put equipment into operation after an
extended storage:
1. Check for loose parts and tighten if necessary.
2. Check for cracked or broken blades and replace.
3. Fill fuel tank.
4. Check oil levels with engine on a flat surface. (refer
to engine manufacturer's owner manual).
5. Start the engine.
6. Check for fuel leaks.
7. Check operation of control handles(s).
14
SC-18A