Classic Accessories WAVEGEAR

To Next Page

5. After attaching ALL three straps

adjust and tighten all the straps so

that your cover is snug and even

across your P.W.C. Roll up any extra

length of strap hanging below the

buckle and secure it with the rip-and-

grip strap keeper at the end of the

strap. This will keep the strap from

ﬂapping in the wind during trailer

transport. For additional security

tuck the extra strap and strap keeper

under the cover.

Gas Tank Doors

You can access

your gas tank

without removing

the cover via

zippered gas

tank access

doors on both

sides of

your cover.

TrailerinG

To use your cover when transporting

your P.W.C. on a trailer you MUST use

all the trailering straps.

Before driving check that all straps

are tight and ﬁrmly attached, that the

strap ends are secured by the strap

keepers and that the gas tank doors

on the cover are zipped shut. After

driving the ﬁrst mile, it’s a good idea

WarninG

When transporting your P.W.C. on a

trailer or an open vehicle be sure to

use and tighten all the straps—the

cover could blow off and cause

injury to others.

CaUTion

Failure to use and tighten all the

straps when transporting your

P.W.C. on a trailer or an open

vehicle can cause damage to

your cover or vehicle.

insTallaTion

1. Cover any sharp points with cloth

or a sponge to avoid stressing or

tearing your cover.

2. Drape your cover over your

personal watercraft (P.W.C.) with the

tapered end marked “FRONT” at

the bow.

3. Pull your cover below the rub rail

around your entire P.W.C.

4. Your cover includes three straps

that secure your cover to your P.W.C.

(These must be used if you are

transporting your P.W.C. on a trailer).

Locate a strap attached to the

bottom of a triangular tension panel

along the hem. Run this strap under

your P.W.C. to the corresponding

buckle on the other side, clip it into

that buckle and tighten as needed.

Repeat with the other two straps.

Instructions: Deluxe Personal Watercraft Cover

to recheck your cover.

Care anD CleaninG

If your cover becomes dirty, it can be

cleaned with lukewarm water and a

soft brush. DO NOT USE SOAP—it

can damage the protective coatings

on the fabric.

sToraGe

To avoid mildew be sure your cover is

completely dry before you store it for

any extended period in its attached

stuff sack.

10cOW55_1131982633, 82643, 20-206-011001-MFF

CLASSIC ACCESSORIES, INC.

KENT, WA USA 98032

2013

classicaccessories.com

Need help?

Do you have a question about the Classic Accessories WAVEGEAR and is the answer not in the manual?

Summary

Installation

Prepare for Installation

Cover sharp points with cloth or sponge to avoid stressing or tearing the cover.

Positioning the Cover

Drape the cover over the P.W.C. with the tapered end marked 'FRONT' at the bow.

Securing the Cover Hem

Pull the cover below the rub rail around the entire P.W.C.

Using Securing Straps

Use three straps to secure the cover, especially for trailer transport. Attach to tension panels and tighten.

Final Strap Adjustment

Adjust and tighten all straps for a snug fit. Roll up excess strap and use keeper to prevent flapping.

Gas Tank Access

Accessing Gas Tank

Access the gas tank without removing the cover via zippered access doors on both sides.

Trailering Precautions

Pre-Trailering Checks

Ensure all trailering straps are tight, firmly attached, and secured. Gas tank doors must be zipped shut.

Post-Driving Check

After driving the first mile, it is advisable to recheck all straps for tightness.

Care and Maintenance

Cleaning Instructions

Clean the cover with lukewarm water and a soft brush. Do not use soap as it can damage coatings.

Storage Guidelines

To prevent mildew, ensure the cover is completely dry before storing it in its attached stuff sack.