4.1.1 Rinse aid prime :
•
Switch machine ON and allow to fill
• Remove the lower front panel (do not
to touch any wire connections).
• Depress and hold button located on
the chemical pump bracket.
• To fully prime, this will take approx 1 ½
minutes.
• Replace the front lower panel.
4.1.2 Detergent / Soap prime :
The detergent / soap pump system on these appliances is self
priming.
4.1.3 Chemical dosage :
Chemical doses are pre-set to the following nominal values,
however these values should be calibrated to suit individual sites
requirements
Pre-set values (in seconds)
Rinse aid Detergent
Machine sizes Cycle
Initial Cycle
Eco 1 5 50 10
Eco 2 & Duo 2 5 70 10
Eco 3 & Duo 3 5 140 10
H500 & Duo 500 5 50 10
H700, H750 & Duo 750 5 90 10
Adjustment of chemical dose is via the timer located under the top
panel of the appliance, the timer allows the following values to be
calibrated to suit the sites requirements
Page 6
To Next Page
Loading...
