OPERATIONS OPERATIONS
13 14
Programme selector
Other Functions
• Instructions of the 【Delay】function
1. When the LED display screen brightens up, rotate
the programme knob to select the desired programme.
2.Select the【Delay】or【Anti-Crease】functions for additional option.
3.Press the【Start/Pause】key.
Press the 【On/Off】button.
Programme start
Programme end
1.The drum will stop running after the programme ends,
. The dryer will start Anti-crease function if user
doesn’t remove the load in time (refer to page 15). Please press key
to cut off power and pull the plug out.
2.Deal with the problems accroding to “Malfunction display and solutions , if there
is a unexpected stop during the drying procedure and the dryer show information
(refer to page 18 ).
the working state LED will
stay light and buzzer will ring. The “Filter” and “Full” LED will remind user to clean
the filters and container. 【 】
【On/Off】
”
The drum will keep rotating after the programme starts, the state light in the display
area will flash in sequence, the remaining time displayed will change automatically.
To delay the drying programme after 3h, 6h, 9h or 12h.
When the delay programme starts, the time starts to decrease and the LED light.
Steps in details:
1.Load your laundry and make sure the machine door is closed.
2.Press the 【On/Off】button,then to turn the programme selector knob and
select a desired programme.
3.You can select the 【Anti-Crease】functions according to your need.
4.To press the【Delay】 key.
5.Continue to press the 【Delay】to select the delay time.
6.After the 【Start/Pause】 key is pushed, the Dryer is at the run condition.
The drying procedure will be automatically performed when the delay time is over.
7.If you push the【Start/Pause】button again, the delay function will be paused.
8.If you want to cancel the “Delay” function, please press the 【On/Off】button.
• Instructions of the Anti-Crease function【 】
At the end of the drying cycle,the anti-crease phase time is 30 minutes (default )
or 120 minutes (selected).
This function prevents the laundry from creases. The laundry can be removed
during the anti-crease phase. Except 【Cool】,【Refresh】,【Warm 30'】and
【Warm 60'】 all the other programmes have this function.
• 【 】Instructions of the Child Lock function
1.This machine incorporates a special child safety lock, which can prevent
children from carelessly pressing keys or making the faulty operation.
2.When the dryer is at the operation state, press the【Anti-Crease】and
【Delay】buttons at the same time for over 3 seconds to start child lock
function. When child lock function is set, the display will show Child lock
icon and no key can effect to the dryer except 【On/ Off】button. Under the
start state of the child lock, the【Anti-Crease】and 【Delay】buttons shall
be pressed at the same time for over 3 seconds to release the child lock
function.
To Next Page
Loading...