23/EN
Clean oven door
To clean the oven door, use warm water with washing
liquid, a soft cloth or sponge to clean the product and
wipe it with a dry cloth.
Don't use any harsh abrasive cleaners or
sharp metal scrapers for cleaning the oven
door. They could scratch the surface and
destroy the glass.
Removing the oven door
1. Open the front door (1).
2. Open the clips at the hinge housing (2) on the
right and left hand sides of the front door by
pressing them down as illustrated in the figure.
3. Move the front door to half-way.
4. Remove the front door by pulling it upwards to
release it from the right and left hinges.
Steps carried out during removing process
should be performed in reverse order to install
the door. Do not forget to close the clips at the
hinge housing when reinstalling the door.
Replacing the oven lamp
Before replacing the oven lamp, make sure
that the product is disconnected from mains
and cooled down in order to avoid the risk of
an electrical shock.
Hot surfaces may cause burns!
The oven lamp is a special electric light bulb
that can resist up to 300 °C. See Technical
specifications, page 11
can be obtained from Authorised Service
Agents or technician with licence.
Position of lamp might vary from the figure.
If your oven is equipped with a round lamp:
1. Disconnect the product from mains.
2. Turn the glass cover counter clockwise to remove
it.
3. Remove the oven lamp by turning it counter
clockwise and replace it with the new one.
4. Install the glass cover.
To Next Page
Loading...
