To Next PageTo Next Page
Need help?Do you have a question about the Clay Paky ALPHA BEAM 700 and is the answer not in the manual?
Procedures and precautions for installing the projector safely.
Specifies the minimum safe distance from objects illuminated by the beam.
Details the minimum safe distance from flammable materials.
Sets the maximum allowable ambient operating temperature for the projector.
Explains the projector's protection level against solid bodies and liquids.
Outlines requirements for safe electrical connection and grounding.
Guidelines for connecting the projector to the electrical mains supply.
Informs about the maximum external surface temperature the fitting can reach.
Procedures and safety precautions for projector maintenance and cleaning.
Information regarding the specific lamp type and its handling.
Warns about optical radiation and specifies safety distances.
How to set the DMX starting address for the projector.
How to set a unique identification address for the projector.
Explains the usage of the control panel buttons and menu navigation.
Setting the DMX address for projector control.
Selecting the channel arrangement for DMX control.
Assigning a unique identification number to the projector.
Configuring network settings for projector control.
Selecting the Art-net control protocol for network management.
Enabling DMX signal transmission to connected projectors.
Assigning a universe number for projector series control.
Manually setting the IP address for network configuration.
Manually setting the subnet mask for network configuration.
Enabling remote control channel for the lamp.
Adjusting Pan and Tilt movement settings and behaviors.
Reversing the direction of the Pan movement.
Reversing the direction of the Tilt movement.
Swapping Pan and Tilt control channels.
Enabling or disabling the Pan/Tilt encoders.
Setting the initial projector reset mode for Pan/Tilt.
Assigning the default Pan home position after reset.
Assigning the default Tilt home position after reset.
Settings related to color mixing and color wheel functions.
Adjusting the CMY color mixing system.
Selecting the curve for color mixing behavior.
Optimizing color change time for gobo wheels.
Controls for the shutter and dimmer functions.
Automatic shutter closing upon Pan/Tilt position error.
Automatic dimmer closing when the strobe is fully closed.
Selecting operating modes for lamp power and fan speed.
Setting display brightness reduction after idle time.
Saving and loading user presets for projector settings.
Viewing and resetting system error messages.
Displaying and resetting total and partial operating hours.
Tracking total and partial lamp operating hours.
Counting total and partial lamp on/off cycles.
Displaying software and hardware versions of projector boards.
Checking the status and error of installed projector boards.
Displaying the projector's DMX channel level.
Monitoring the speed of installed fans.
Checking the operational status of projector sensors.
Displaying network parameters like IP address and MAC address.
Turning the projector lamp on or off from the control panel.
Resetting the projector to its default or initial state.
Setting individual channel levels for DMX control.
Performing functional tests on projector effects.
Accessing advanced settings via an access code.
Transferring firmware to connected fixtures.
Changing the projector's default model setting.
Adjusting effects for uniformity between projectors.
Restoring all settings to factory default values.
Guidelines for periodic cleaning of projector components.
General
