16
Disconnect the machine from the power source before making any repairs.
Symptom Cause Solution
Motor does not run
when “ON”, fully con-
nected and trigger
depressed.
On/Off switch is in the
“OFF” (O) position.
Turn switch to the “ON” ( I
) position.
GFCI is not plugged in. Plug in GFCI.
Extension cord is too long.
Extension cord is not
proper gauge.
Extension cord is dam-
aged.
Replace extension cord
with either a 25’ (7.6 m)
14/3 gauge cord or a 50’
(15 m) 14/3 gauge cord.
Electrical outlet does not
supply adequate power.
Try a different outlet.
Tripped pressure washer
thermal protector.
Allow to cool, and restart
unit.
Unit does not reach high
pressure.
Diameter of garden hose is
too small.
Replace with a 1” (25 mm)
or 5/8” (16 mm) garden
hose.
Water supply is restricted.
Check garden hose for
kinks, leaks and blockage.
Not enough water supply. Open water source fully.
Water inlet lter is clogged.
Remove lter and rinse in
warm water.
Power nozzle is in low-
pressure position.
Replace with desired high-
pressure tip.
Pump is sucking air.
Check that hoses and t-
tings are airtight. Turn
“OFF” machine, and purge
pump by squeezing trigger
gun until a steady ow of
water emerges through the
nozzle.
TROUBLE SHOOTING
To Next Page
