EN
15
Fresh Water Tank
L
Before the device is used, the
water tank cap must be attached
to the bottom of the fresh water
tank.
• Attaching:
Insert the fresh water
tank(13) via the guide rail into the
mount for the fresh water tank(3).
You must hear and feel the locking
catch(14) engage.
• Detaching: Pull the locking catch
away from the device to release the
locking lug (PictureC).
• Opening and closing: To open it,
unscrew and remove the cap(11) on
the bottom of the fresh water tank.
To close the fresh water tank, place on
the cap and screw it on tight.
Nozzles
The nozzle with brushes (12) is suitable
for cleaning rugs. The transparent cover
can be removed to clean the nozzle.
The nozzle (9) is suitable for cleaning
upholstery such as sofas, armchairs, car
seats etc.
• Attaching: Slide the nozzle onto the
handle (6). When you do this, make
sure that the nozzle and handle are
correctly above one another so that
the locking button(7) can engage.
• Detaching: Press the locking button
on the top of the handle firmly and
pull the nozzle off the suction hose.
• Detaching and attaching the cover
of the nozzle with brushes(12): Lift
up the tab on the top of the nozzle to
detach the cover.
When you attach it, make sure that
you hear and feel the tab engage.
FILLING THE FRESH WATER
TANK
Please Note!
■ The feed opening is located on the
bottom of the fresh water tank.
■ Do not pour cleaning agent into the
fresh water tank, but instead spray
it directly onto the surface to be
cleaned if necessary.
1. Remove the fresh water tank(13) from
the device to fill it, turn it with the
opening facing upwards and open it
(see the “Attaching and Detaching
Accessories” chapter – “Fresh Water
Tank”).
2. Fill the fresh water tank with clean
water (max. 40°C). Note the MAX
marking. Do not overfill the fresh
water tank!
3. Close and reinsert the fresh water
tank.
USE
Please Note!
■ Only connect the mains plug to a plug
socket that is properly installed and
matches the technical data of the de-
vice. The plug socket must be readily
accessible after connection so that the
connection to the mains can quickly
be isolated.
■ Only use suitable extension cables
whose technical data is the same as
that of the device.
■ Note the MAX marking on the dirty
water tank and do not exceed it to
prevent the motor from being over-
loaded
(see the “Cleaning the De-
vice” chapter – “Dirty Water Tank”).
■ Clean the filters regularly to prevent
the motor from being overloaded.
Replace if necessary.
To Next Page
Loading...
Need help?
General
