19 EN
Items Supplied
1 x main unit
with dirty wa-
ter container
1 x fresh
water con-
tainer
1 x handle
1 x upholstery nozzle
with hose
2 x screw
(premount-
ed on main
unit)
1 x cleaning agent
Before Initial Use
A cross-head screwdriver is required for assembly.
1. Check the items supplied for completeness (see the “Items Supplied” chapter) and
possible transport damage. If you fi nd any damage to the components, do not use
them (!), but contact our customer service department.
2. Insert the handle (1) into the opening of the container sup-
port (14) and align it so that the curved end of the han-
dle (1) points towards the back of the device. Fix the han-
dle (1) in place using the two screws that are supplied with
the device.
3. Insert the fresh water container (2) into the container sup-
port (14).
When you do this, make sure that the locking
lugs on the fresh water container
(1) fi t in the recesses in
the
container support (14). Press the fresh water contain-
er (2) against the handle (1) until you hear it engage.
The dirty water container (8) is already inserted in the main unit.
Use
Preparing the Carpet
1. Vacuum the carpet or upholstered furniture which is to be cleaned thoroughly with a
vacuum cleaner. If possible, use a brush attachment to do this.
2. If possible, remove all furniture from the carpet. In the case of large items of furniture
which cannot be moved to one side, place plastic fi lm below or around the feet and
only remove it once the carpet has completely dried after it has been cleaned. The
feet could be damaged by the moisture from the carpet.
To Next Page
Loading...
Need help?
General
