Cleanmaxx WS-19 - Assembling the Device; Before Initial Use; Device Overview

EN 16
Device Overview
12
1
4
5
8
3
9
2
11
10
6
7
1 On / Off button
2 Telescopic tube
3 Telescopic tube mount
4 Charging socket (on the back)
5 Main unit with water tank
6 Cleaning feet with mop pads
7 Spray nozzle
8 Control lamp
9 Water tank cap
10 Slider for adjusting the length
11 Handle
12 Spray button
Before Initial Use
• Remove any possible fi lms, stickers or transport protection from the device. Never
remove the rating plate and any possible warnings!
• Assemble the device (see the “Assembling the Device” chapter).
• Charge up the battery (see the “Charging Up the Battery” chapter).
Assembling the Device
1. Guide the connecting cable of the handle (11) fully through the telescopic tube (2).
2. Plug the handle onto the top of the telescopic tube. It must engage audibly.
3. Connect the plug connector of the connecting cable to the socket of the main unit (5).
It must engage audibly.
4. Plug the telescopic tube into the telescopic tube mount (3) of the main unit. It must
engage audibly.
To detach the telescopic tube or handle, in each case press the corresponding release
buttons and pull out the respective part. NOTICE: When you take it apart, it is essential
to ensure that the plug connector of the connecting cable is disconnected.