CLEAR DESIGN BLADE BBC1 - Attach BB3 Beam to Connector Bracket; Measure Width and Lock into Position

11
60" W RETURN
#"
5 | ATTACH BB3 BEAM TO CONNECTOR BRACKET
Slide connector bracket over the side of the BLADE main surface beam. Once
seated, guide return beam tabs into the bracket holes, ensure that there is no
gap between the beam and legs. Using a rubber mallet, hammer beam to lock
in place.
6 | MEASURE WIDTH AND LOCK INTO POSITION
Measure from end leg to end leg until you fine the approximate width of the work
surface. To find the optimal placement for locking, insert the screw through the
overlapping beam slots and into the black plastic piece. Slightly tighten the screw
with only a few turns. DO NOT fully tighten.
#"