Clear2O CWS100 - Pitcher Connection

Example: If your FEMALE faucet aerator fits any of the 55/64”-27 threads, then you
require the following adapter: Female 55/64”-27 x Male 55/64”-27.
Example: If you 1” MALE faucet aerator fits the Female 3/4”-27 adapter, then you require
the following adapter: Male 3/4” -27 x Male 55/64”-27.
In all cases, the LOWER portion of the adapter should measure Male 55/64”-27.
Although less commonly used, the adapters are widely available online and at hardware, &
plumbing supply stores. At the time of this writing, you can find additional adapters on our
website at www.clear2o.com. If you choose to find locally, most hardware and plumbing
stores stock these in the Faucet Repair section, usually in the same shelf location as
replacement “faucet aerators & faucet parts”. It is recommended to take your faucet
aerator with you to insure you find the right adapter size.
If you continue to have difficulty with your installation, please contact us at
support@clear2o.com for further instructions.
If the enclosed adapters do not fit, please do not return to store.
Contact CLEAR
2
O for assistance at support@clear2o.com.
1. Pull the quick-connect hose out of
the storage compartment located
on the pitcher handle.
2. Grip Quick-connect hose connector
with one hand, pull down on the
outer ring and hold. With the other
hand, grasp the faucet to provide
stability.
3. Insert faucet adapter into
quick-connect fully.
4. Release the outer ring upward.
Gently tug on the connector to
ensure it is securely on the faucet.
IMPORTANT: To avoid damage to the
hose connector, you must pull back and
hold the connector’s outer ring before
inserting onto the faucet.
5. To release, pull down on outer ring
and remove quick-connect hose.
PITCHER CONNECTION
7