Clear2O GRP200 - Removing and Replacing Filter; Operating and Safety Requirements; Usage and Temperature Guidelines; Troubleshooting

TROUBLESHOOTING
Problem Possible Cause Solution
Filter is not seated correctly
1) Lid is not rmly in place
to trigger lter indicator
2) 60 gallon limit has
not been reached
3) Filter is not seated
properly
Water Pitcher should be
kept in refrigerator at cold
temperature
Water bypasses lter
Filter indicator does not
change
Filter appears green
Remove and re-insert lter
correctly into place
1) Firmly push down
lid to close
2) Continue to use until
indicator changes
3) Remove and re-insert
lter correctly
Replace lter
OPERATING AND SAFETY REQUIREMENTS
• Water Temperature : Max 85° F – Min 34°F
• It is essential to follow the operational maintenance and lter
replacement instructions for this product to perform as designed.
• Replace lter after 60 gallons of ltered water.
• Do not microwave pitcher or lter.
• Do not immerse or ll the pitcher with boiling water.
• Do not place pitcher or lter in the freezer or allow it be kept in
freezing temperatures.
• Do not drink water that is microbiologically unsafe or of unknown
quality without adequate disinfection before or after using this system.
• Not intended to be used with fruit, vegetables and/or herbs.
• For best results, change water in the Gravity™ Advanced
Water Pitcher every few days.
REMOVING & REPLACING FILTER
1. Select a level countertop space. Hold the water reservoir in the
upright position and lift pitcher lid to open.
2. Remove lter by twisting counter clockwise until lter is released.
3. Remove lter from pitcher and discard or place in recycle bin.
4. Remove replacement lter from the packaging.
5. Rinse lter under cold, running tap water for a few seconds to wet
lter and remove any debris from manufacturing.
6. Re-insert into place and rotate lter clockwise until stop.
Filter should be securely attached.
7. Discard the rst 3 pitchers of ltered water to ush the pitcher, or
use this water for plants. It is normal for carbon dust to appear in
your rst llings.
8. Fill the pitcher with cold tap water through the water window
pour through lid.* Do not overll.
9. Allow water to lter completely before pouring or relling reservoir.
10. Close water window pour through lid when the reservoir is full.
6