15
Power Saving Feature
To save power, the scanner will automatically go into
“sleep” mode if not used for 3 minutes. You may
“wake up” the scanner by pressing any button. If the
scanner is not used for 6 minutes, it will automatically
turn off.
How To Clean The Scanner For Film Scanning
Use the supplied brush to clean the backlight panel:
turn off and disconnect the QuickConvert® 2.0, insert
the brush in the slot where you would normally insert
the film holder, and brush gently.
How To Adjust Exposure/Brightness
Before scanning, you can adjust the scanner’s
exposure to make the scanned images lighter or
darker.
To adjust exposure value, press the “EV” button before
scanning. The exposure menu will appear. Use the
“UP” and “DOWN” arrow buttons to set the exposure
setting as desired. Then press the “EV” button again to
save the setting.
To Next Page
Loading...
