Why is there a loss of water pressure in my Clearion Water Filtration System?
A loss of water pressure in your Clearion Water Filtration System can occur due to: * Scaling or fouling of the inlet pipe: Clean or replace the pipeline and consider pretreatment to prevent future issues. * Fouled media: Clean the media and pretreat to prevent recurrence. * Improper backwash setting: Increase the frequency of backwashing.
What to do if my Clearion Water Filtration System continuously flows to the drain?
If your Clearion Water Filtration System experiences continuous flow to the drain, it could be due to: * Foreign material in the control valve. * An internal control leak. * The valve being jammed in the backwash, brine, or rapid rinse position. * A stopped or jammed motor. In all of these cases, you should contact your dealer to clean the valve and replace the piston and seals. If the motor is unresponsive, it should also be replaced. Check for jammed piston.
General| Brand | Clearion |
|---|---|
| Model | 300 Series |
| Category | Water Dispenser |
| Language | English |
To Next Page
