5) Installing the Under Bench Support and Bench:
• Slide the Under Bench Support Panel down the wooden supports with the heater facing
out.
• Make sure the two side slots of the Bench Support Panel slide completely into the
corresponding grooves of the wooden supports . (Refer to Photo 1)
•
Connect the power connector from the back of the Under Bench Support Panel to the floor
Panel then connect the other power connector from the back of Under Bench Support
Panel to the Right Wall Panel. Ensure the connection is completely fastened (Refer to
Photo 2)
•
Place the Bench on the Bench Support Panel and slide toward the Back Wall until flush to
the Back Wall. (Refer to Photo 3)
1 2 3
6) Place the front panel in the slot of floor panel .
7) Place the top panel on the four side panels. Make sure the connection wires from the three side
panels protrude through the corresponding holes of the top panel.
• Make sure the top panel’s arched side is facing to the front.
• Make sure the wire is through each hole smoothly and completely.
• Make sure trim of the top panel fits completely around the four side panels.
7
To Next Page
Loading...
