Clearlight PREMIER IS-2 - Page 15

EU +44 118 324 1242 | Germany +49 361 7473 4613
www.clearlight-saunas.eu
15
PREMIER IS-1, IS-2 AND IS-3
Assembly Instructions Cont’d
1. Plug in the light xture to the left back wall plug and screw the light xture in place.
2. Place the wooden light shade over the installed light xture. The light shade will attach by the installed
magnets.
12 - INSTALLING THE INSIDE LIGHT FIXTURE AND WOOD LIGHT SHADE
Light Fixture
Light Shade
Light Fixture and Light
Shade installed
13 - LOCATING AND PLUGGING IN POWER CORD
The power cord comes out of the roof of the sauna. If you are standing facing the sauna, it comes out of the rear
left corner of the roof. Open the trap door to access the power cord and run the cord down the back of the sauna.
The power cord will plug into the appropriate electrical receptacle.
Note: We do not recommend using an extension cord for your sauna.
Please plug the sauna directly into the wall receptacle.
Light Fixture