Technical Support: 1 (219) 929-4127
6 Digital-1 User’s Guide
Tuning
Channel Selection
The Digital-1 receiver is digitally tuned. Once a
channel is selected, no further adjustments are
necessary. The factory preset for the Digital-1
receiver is channel 19 (72.95 MHz).
The step-by-step instructions and diagrams
below and on the facing page show you how to
change the receiver’s preset. See page 8 for
frequencies corresponding to other channels.
❑ Step 1
Remove the battery cover from the back of the
receiver.
❑ Step 2
Remove the two Phillips case screws and remove
the back panel.
To Next Page
Loading...