Technical Support: 1 (219) 929-4127
Digital-1 User’s Guide 9
Correcting Interference
With any type of radio-frequency (RF) device,
other RF sources can interfere with reception.
Even the Assistive Listening Band is occasion-
ally subject to use by other types of devices.
To check for on-channel interference, take the
Digital-1 receiver to the place where the interfer-
ence is the worst and turn off the transmitter. The
interfering signal should now become stronger.
Set the TX-37A transmitter and the receivers to
a different channel and return to the same place.
If interference continues, try changing channels
again until you get a clear signal.
If more than one TX-37A is operating in the same
area, try to keep the channels used as far apart
as possible (3 channel spacing recommended).
To Next Page
Loading...