10
Step 1
Prepare car seat for Forward-Facing
Installation:
• If Rear-Facing Base or Anti-Rebound
Bar is attached, remove it now, see
“Installing/Removing Rear-Facing Base”
and “Installing/Removing Anti-Rebound
Bar” in your car seat manual.
Step 2
Select a Forward-Facing vehicle seating
location which has LATCH.
Locate the LATCH lower anchors and top
tether anchor (as explained in the “Vehicle
Child Restraint Anchorage System (LATCH)”
in your car seat manual and in your vehicle
owner’s manual). See Figure 11.
Step 3
If the vehicle seat back is adjustable, make
sure the seat back is locked in a more upright
position. Refer to vehicle owner’s manual for
recommended seat back angle. DO NOT
install or use this car seat while the vehicle
seat back is excessively reclined, as shown in
Figure 12.
Figure 11
Figure 12
To Next Page
Loading...
