Removing/Installing Canopy Rod
REMOVING CANOPY ROD
Step 1
Extend canopy: Grasp zipper tab and unzip canopy extension, then grasp front of
Canopy and pull it forward.
Step 2
Locate canopy rod in canopy hub and gently pull up at the base to remove it from
the canopy hub, as shown in Figure 1. Repeat on the other side.
Step 3
Remove canopy rod from canopy sleeve by pulling gently.
INSTALLING CANOPY ROD
Step 1
Position canopy rod so that the ends are facing away from you and curving up, as
shown in Figure 2.
Step 2
Use right hand to pick up the right side of the canopy rod and insert end through
bottom of elastic loop on the left side of canopy, as shown in Figure 3.
Step 3
Insert end of canopy rod into canopy sleeve, as shown in Figure 4.
Push canopy rod through canopy sleeve until the end of the canopy rod comes out
the other side. If the canopy fabric bunches, it may be necessary to slide the canopy
fabric along the canopy rod from the top of the canopy as the canopy rod reaches
the right side of the canopy.
Step 4
Insert end of canopy rod through top of elastic loop on right side of canopy, and
even the canopy rod out.
Step 5
Insert end of canopy rod into hole in canopy hub and push down to make sure it is
fully seated, as shown in Figure 5. Repeat on other side.
Step 6
Check to make sure that both ends of canopy rod are through the elastic below the
canopy sleeve on each side of the canopy, and fully inserted into the hole in the
canopy hub.
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
To Next Page
Need help?
General
