CLEVERSPA BLACK LABEL - Completing CleverSpa Setup; Filter, Water, and Cover Installation; Inflation Valve Maintenance

SETTING UP BLACK LABEL CLEVERSPA
®
Screw Filter Cartridge (G)
onto Filter Connector (V).
Add Filter Protector Cover (L)
onto Filter Cartridge (G).
G
Add water to level.
No higher than ‘MAX’ level.
Clip-on Top Cover (H)
to retain the heat.
Set temperature on control panel.
See page 10 for full operating instructions.
Double lock clips with
Safety Locking Keys (I).
V
09
M
15
13
1716
14
18
W
P
N
Over time inflation valve (P) may become loose. Use supplied valve wrench (N)
to tighten, maintaining air seal.
FOLLOW THE STEPS 19 & 20 BELOW:
IMPORTANT: WHILST USING THE WRENCH - DO NOT
LOOSEN VALVE AS IT WILL FAIL.
TIGHTENING INFLATION VALVE
19 20