Clevo N250WU - Removing the Keyboard

Disassembly
2 - 10 Removing the Keyboard
2.Disassembly
Removing the Keyboard
1. Turn off the computer, turn it over to remove the battery (page 2 - 5).
2. Remove screws - from the bottom case (Figure 5a).
3. Open it up with the LCD on a flat surface before pressing at point
to release the keyboard module while releas-
ing the keyboard in the direction of the arrow
as shown (Figure 5c).
4. Carefully lift the keyboard up, being careful not to bend the keyboard ribbon cable . Disconnect the key-
board ribbon cable from the locking collar socket (Figure 5d).
5. Carefully lift up the keyboard off the computer (Figure 5e).
1
2
3
4
5
6
7
5
b.
c.
a.
7
1
5
6
7
5
2
4
3
d.

5. Keyboard
•2 Screws
Figure 5
Keyboard Removal
a. Remove the screws.
b. Release the keyboard by
pressing at point .
c. Disconnect the keyboard
ribbon cable from the
locking collar socket.
d. Remove the keyboard.
3