Clevo N250WU - Removing the 3 G Module

Disassembly
2 - 14 Removing the 3G Module
2.Disassembly
Removing the 3G Module
3G Module Removal Procedure
1. Turn off the computer, turn it over to remove the battery (page 2 - 5) and bottom cover (page 2 - 6).
2. The module will be visible at point on the mainboard (Figure 8a).
3. Carefully disconnect the cables & , and then remove the screw from the module
(Figure 8b).
4. The module will pop-up (Figure 8c).
5. Lift the module up and off the computer (Figure 8d).
1
2
3
4
5
5
b.
c.
a.
2
1
5
3
4
5
d.

3.M2 SATA-1 Module
•1 Screw
Figure 8
3G Module Removal
a. Locate the module.
b. Disconnect the cables
and remove the screw.
c. The module will pop up.
d. Lift the module up and
off the socket