Clevo NH55EDQ - Page 30

Disassembly
2 - 8 Removing the Hard Disk Drive
2.Disassembly
5. Remove screws from the HDD assembly (Figure 4b).
6. Slightly lift and pull the hard disk assembly in the direction of arrow (Figure 4c).
7. Lift the hard disk assembly out of the bay (Figure 4d).
8. Remove screws - and bracket from the hard disk (Figure 4e).
9. Reverse the process to install a new hard disk (replace the bottom case by inserting at point first as shown in
Figure 3b, do not forget to replace the screws).
18
19
20 21
22 23 24 25
1
d. e.
24
20
HDD System Warning
New HDD’s are blank. Before you begin
make sure:
You have backed up any data you want to
keep from your old HDD.
You have all the CD-ROMs and FDDs re-
quired to install your operating system and
programs.
If you have access to the internet, down-
load the latest application and hardware
driver updates for the operating system you
plan to install. Copy these to a removable
medium.
g.
18
19
23
22
25
21
f.
20. HDD Assembly
24. Bracket
25. HDD
• 3 Screws
Figure 4
HDD Assembly
Removal (cont’d.)
d. Remove the screws.
e. Slightly lift and pull the
HDD in the direction of
the arrow.
f. Lift the HDD assembly
out of the bay.
g. Remove the screws and
bracket from the HDD.