Clevo NP70HH - Page 36

Disassembly
2 - 12 Removing the M.2 SSD Module
2.Disassembly
M.2 SSD-2 Installation Procedure
1. Turn off the computer, turn it over, remove the battery (page 2 - 5) and hard disk (page 2 - 8).
2. Disconnect the HDD connector cable
, (remove the screw and HDD bracket , if available) (Figure 8a).
3. Insert the SSD bracket in place and tighten screws -
(Figure 8b).
4. Insert the M.2 SSD module (Figure 6c), and tighten the screw (Figure 8c).
1
2
3
4
5
7
8
9
b.
c.a.
5
4
1
8
7
2
6
3
8
9

3.HDD Bracket
4.SSD Bracket
•5 Screws
Figure 8
M.2 SSD-2 Module
Installation
a. Locate the M.2 SSD.
b. Remove the screw.
c. The M.2 SSD module
will pop up.