Disassembly
2 - 14 Removing and Installing a Processor
2.Disassembly
Processor Installation Procedure
1. Insert the CPU (Figure 10a), and pay careful attention to the pin alignment; it will fit only one way (DO NOT
FORCE IT!), and turn the release latch towards the lock symbol (Figure 10b).
2. Remove the sticker (Figure 10c) from the heat sink unit.
3. Insert the heat sink as indicated in Figure 10c.
4. Tighten the CPU heat sink screws in the order
, & (the order as indicated on the label and Figure 10d).
5. Replace the CPU fan, component bay cover and tighten the screws (page 2 - 12).
b.
B
a.
D
Note:
Tighten the screws in the order as
indicated on the label.
A
c.
d.
1
2
3
C
D
Figure 10
Processor
Installation
a. Insert the CPU.
b. Turn the release latch to-
wards the lock symbol.
c. Insert the heat sink.
d. Tighten the screws.
A. CPU
D. Heat Sink
•3 Screws
To Next Page
Loading...
