To Next PageTo Next Page
Need help?Do you have a question about the Clifford 5806X and is the answer not in the manual?
General| Brand | Clifford |
|---|---|
| Model | 5806X |
| Category | Remote Starter |
| Language | English |
The system keeps the engine running until the vehicle is ready to be driven. Disarm system, enter vehicle, turn key, step on brake.
Activation begins a countdown timer as set by the installer. When the timer expires the engine starts and the Remote Start On message is sent.
Smart Start uses settings for Timer Start plus temperature and battery level to automatically start the engine. Activation begins the countdown timer.
The alarm arms, doors lock (if connected), and the siren chirps and parking lights flash once. The Arm LED and beeps play to confirm.
Activates (or if On, deactivates) the remote starter. The engine and parking lights turn On and the Remote start LED and On tones play.
The alarm disarms, doors unlock (if connected), and the siren chirps and parking lights flash twice. The Disarm LED and beeps play to confirm.
If more time is needed while remote start is active, runtime reset will reset the runtime counter to the pre-programmed setting.
Activates (or if On, deactivates) Timer Start. The parking lights flash quickly four times for On and slowly four times for Off.
Due to the complexity of this system, installation of this product must only be performed by an authorized Directed dealer.
When properly installed, this system can start the vehicle via a command signal from the remote control transmitter. Never operate in enclosed areas.
Remote starters on manual transmission vehicles operate differently than those with automatic transmission because you must leave your car in neutral.
