Need help?Do you have a question about the Clifford intelliGuard 750 and is the answer not in the manual?
Provides a visual diagram illustrating the connection points of the primary 18-pin wiring harness.
Provides a diagram for the 6-pin secondary wiring harness connections.
Explains how to connect the immobilizer harness by cutting ignition and starter wires.
Explains the UltraSecure immobilizer circuit and its design for reliability.
Details interfacing with door lock systems that use a positive 12-volt pulse for operation.
Explains interfacing with door lock systems that use a negative pulse for operation.
Details interfacing with door lock systems that use reversing polarity for control.
Explains how to control aftermarket door lock actuators with the system.
Details interfacing with Mercedes-Benz and Audi door lock systems using a vacuum pump.
Explains interfacing with one-wire door lock systems, common in certain Nissan models.
Details interfacing with positive multiplex door lock systems with resistors.
Explains interfacing with negative multiplex door lock systems with resistors.
Details using Cliffnet Wizard Pro software for system programming.
Instructions for setting and confirming the system's PIN code.
Explains programming options for various accessory channel outputs.
Steps to disable sensors using the remote control.
Describes the 506T Audio Sensor for detecting glass breakage sounds.
Provides guidance on adjusting the sensitivity of the audio sensor.
To Next Page
General