40
•
Unpack the appliance and visually check that it is not damaged.
Do not connect a damaged appliance. Inform your retailer or point
of sale of any damage. In such a case, keep the packaging.
•
It is recommended that the appliance be allowed to settle for at
least 4 hours before connecting the electrical power supply, so that
the compressor fluid feed is correct.
•
Proper air circulation is necessary to avoid overheating. To
ensure sufficient ventilation, observe the installation
recommendations provided.
•
In order to avoid fire risk, wherever possible, ensure that the
appliance is not in contact with walls or with any hot element
(compressor, condenser). Observe the installation
recommendations.
•
The appliance should not be placed close to radiators or cooking
hot plates or gas rings.
•
Check that electrical sockets remain accessible when the
appliance is installed.
POWER SAVING
To limit the electricity consumption of your appliance:
• Install it in an appropriate place (see “Installing your appliance”).
• Leave the doors open as little time as possible.
• Do not put food that is still hot into the appliance.
•To ensure that the appliance operates properly, clean the
condenser regularly (see “Routine servicing of your appliance”).
• Regularly inspect the door seals and ensure that they are still
closing properly. If this is not the case, contact your after-sales
service.
Trouble shooting
•
Any electrical work should be carried out by a qualified and
skilled technician.
To Next Page