19
4. INSTALLATION INSTRUCTIONS
Before using your thermoelectric cooler
▪ Remove the inner and outer packaging.
▪ Allow the appliance to rest for two hours before switching it on.
▪ Clean the inside using a soft cloth and lukewarm water.
Installing your appliance
▪ This device is only intended to be installed in free standing, in no case it must be installed in
a built-in or embeddable way. For a good functionality of the device it is imperative to leave
a good air circulation all around the device. We do not take responsibility for failure to comply
with the installation instructions.
▪ Position it in a place with sufficient strength to support its weight when loaded. To ensure that
it is level, adjust the height of the feet underneath.
▪ To get the best from your appliance with the lowest energy consumption, do not place the
appliance close to a heat source (heater, cooker, etc.), do not expose it to direct sunlight, and
do not place it in a room which is too cold.
▪ Connect the appliance to a single socket, leaving a 10 cm gap between the back of it and the
wall and 2 cm on each side. Be careful to support it, so that it is perfectly level. (Use of a spirit
level is recommended). This will prevent any movement due to instability, causing noise and
vibration, and will ensure that the door seals perfectly.
Ambient room temperature limits
This appliance is designed to operate in ambient temperatures specified by its temperature class
marked on the rating plate.
To Next Page
Loading...
Need help?
General
