Climate Technology Bonaire

Questions and Answers

R
Ryan GonzalesJul 31, 2025
What to do if my Climate Technology Remote Control unit fails to start?
- G
  griffithanitaJul 31, 2025
  If your Climate Technology Remote Control unit fails to start, it could be due to several reasons: a blackout, a tripped circuit breaker, a blown fuse, or an electrical fault. In the event of a blackout, wait for the power to be restored. If it's a tripped circuit breaker, reset it. For a blown fuse, replace it. If you suspect an electrical fault, call a Climate Technologies Service Provider.
K
Kimberly RuizAug 6, 2025
Why is there excessive humidity with my Climate Technology Bonaire Remote Control?
- R
  Robert WernerAug 7, 2025
  Excessive humidity with your Climate Technology Remote Control may be due to inadequate relief or high outside humidity. To address this, provide more open area to relieve stale air. Alternatively, turn the pump off.
E
Emily CollinsAug 12, 2025
What to do if there are water droplets in the air stream of my Climate Technology Remote Control?
- T
  Tammie DuncanAug 12, 2025
  If you notice water droplets in the air stream of your Climate Technology Remote Control, it could be due to a loose delivery tube, a break in the tubing, or the pump delivering excessive water to the pads. Check and tighten any loose delivery tubes. Replace any broken tubing as necessary. If the pump is delivering too much water, adjust the Dialflo to reduce the flow.
T
Tammy FrankAug 18, 2025
What to do if the pump fails to start on my Climate Technology Remote Control?
- T
  Tammy HinesAug 19, 2025
  If the pump on your Climate Technology Remote Control fails to start, it could be either seized or burnt out. If the pump is seized, isolate the power, take off the top of the pump, and try to free it, using some lubricant if needed. If the pump is burnt out, call a Climate Technologies Service Provider.
D
Danielle WadeAug 25, 2025
How to fix water leaking from the overflow in my Climate Technology Remote Control?
- T
  Tina MorganAug 25, 2025
  If water is leaking from the overflow in your Climate Technology Remote Control, it may be due to a leaking float valve or drain from Celdek pads. Check the float valve adjustment or replace the seal. Note that drain from Celdek Pads is normal operation.