3
Step 7. Replace the Top cover and tighten the bottom screw using a Philips screwdriver.
Step 8. Enable Siren Tamper function in the Control Panel (Please refer to the Control Panel instruction manual)
Step 9. Check if the installation is successful by testing from the Control Panel by arming and disarming function.
Successful arming/disarming is indicated by the table provided in Audio & Visual Status Indication.
<NOTE>
If 5 short-beeps are noticed while arming/disarming, it means the tamper is not fully depressed. Check to ensure that tamper is
properly set and then test from Control Panel again.
Step 10. The installation is now completed.
Changing the Battery
Step 1: Disable the Siren Tamper function on the Control Panel (please refer to the Control Panel instruction manual). The Bellbox will sound a
beep to indicate the tamper switch is now disabled.
Step 2: Release the cover-fixing screw at the bottom of Bellbox using a Philips screwdriver and pull the outer case out carefully.
Step 3: Slide battery switch to the off position.
Step 4: The battery compartment is a large box in the Bellbox with a lid secured by 2 screws. Release the screws using a Philips screwdriver and
take off the compartment lid.
Step 5: Remove the old batteries and press the Tamper Switch a couple times to discharge.
Step 6: Insert new batteries into the battery compartment.
Step 7: After inserting batteries, slide the battery switch to ON position. All LEDs will flash once and the buzzer will emit 1 beep as the Bellbox
powers on.
Step 8: Replace and secure the battery compartment lid, with 2 screws using a Philips screwdriver.
Step 9: Replace and secure the Top cover by tightening the bottom screw using a Philips screwdriver.
Step 10: Enter the Control Panel Sound/Siren setting webpage to enable the Siren Tamper function again. The Bellbox will sound a beep to
indicate the tamper switch is now activated.
Factory Reset
The Bellbox can be reset and memory contents cleared. Whenever the Bellbox is removed from the Control Panel, it should be put to factory reset
to clear its Control Panel memory, otherwise the Bellbox will still raise alarm if it receives alarm signal from panel.
Step 1: Disable the Siren Tamper function on the Control Panel (please refer to the Control Panel instruction manual). The Bellbox will sound a
beep to indicate the tamper switch is now disabled.
Step 2: Remove the Bellbox from Control Panel device list (please refer to the Control Panel instruction manual).
Step 3: Release the bottom screw of the Top cover using a Philips screwdriver, remove the top cover..
Step 4: Slide the battery switch to the OFF position.
Step 5: Press and hold the Learn Button and slide the battery switch to BT4 terminal. Continue to hold the Learn Button for 7 seconds. Release
the Learn Button when you hear 2 short beeps and a long beep. The previous parameters in the Bellbox will be cleared and it will return
to normal mode.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
To Previous Page
Loading...
