CLIMET INSTRUMENTS CI-90A - Technical Specifications

CI-90A User’s Manual
Page 9
1.6 Specifications
Sample Lid:
Clear Anodized Aluminum with 333 0.0225” holes,
OR (depending on model ordered)
Passivated 316 Stainless steel with 333 0.0225” holes.
Autoclavable @ 134C for 20 minutes
Enclosure:
304L Stainless Steel
Sample flow rate:
100 liters per minute (0.10 cubic meter or 3.53 cubic feet per minute)
Flow rate control:
Electronic, automatic closed loop
Battery:
Replaceable 9.6 Volts, 7.6 Amp hour Nickel Metal Hydride
Battery operation time: 7.5 to 9 hours of continuous operation
Time to charge battery: 4.0 to 4.5 hours
Display:
4x20 character LCD
Printer:
Thermal Dot Matrix, prints on 5/8” tall by 2” wide thermal labels
Unit ID:
User selectable; 6 characters long.
User ID:
Up to 10 users; 9 characters long.
Security:
Security to prevent settings changes, or aborting a sample in progress
Location ID:
Up to 100, 15 characters long.
Input/Output:
RS-232 9600 bps, 8-bit, 1 stop, no parity, no handshaking
Audible alarm:
Built-in
Alarm limits:
 10% deviation from 100 LPM flow rate.
Dimensions:
H-W-D: 7.5 X 8.1 X 9.9 inches (19.0 X 20.6 X 25.1 cm)
Weight:
9.9 lb (4.5 Kg) with battery
Power:
Auto switching: 100–240 VAC, 47/63 Hz
Operating range:
0–36º C, 10–90% RH, non-condensing
Calibration:
Factory Prime Calibration of flow system accuracy.
Calibration frequency:
Recommended every 12 months.