7
2.1 PRELIMINARY INFORMATION
2 - RECEPTION
2.2 DELIVERY CONTROL
2.3 HANDLING
Considerer that the barycentre could out of centre
Use protection to avoid the unit damaging
General
Operate in compliance with safety regulations in force .
For detailed information (dimensions, weight, technical
characteristics etc.) please refer to the “Technical
information” section.
Use single protection devices : gloves, glasses ecc.
Stocking
Observe external packing instructions .
Handling
Verify unit weight and handling equipment lifting
capacity .
Identify critical points during handling (disconnected
routes, flights, steps, doors).
Verify the position of the barycentre in the Technical
information - DIMENSIONS section.
Before handling verify that the unit keeps its balance.
Packing removing
Be careful not to damage the unit.
Recycle and dispose of packing material in conformity
with local regulations.
Before accepting the delivery you have to check:
• That the unit hasn’t been damaged during tran-
sport.
• Check that the materials delivered correspond
with that indicated on the transport document
comparing the data with the identification label ‘A’
positioned on the packaging.
In case of damage or anomaly:
• Write down on the transport document the da-
mage you found and quote this sentence:
"Conditional acceptance — clear evidence of
deficiencies/damages during transport".
• Contact supplier and the carrier by fax and regi-
stered mail with advice of receipt.
Any disputes must be made within the 8 days following
the delivery. Complaints after this period are invalid.
To Next Page
Loading...
Need help?
General
