CLIVET ID2-XY 35M User Manual

Product Features
 Page 83 
Putty
Putty
Putty
Trap
Trap
Trap
Note: DO NOT allow water to enter the remote control. Use the trap and putty to seal the wires.
• For exposed mounting, four outletting positions. There are three need cutting.
Cutting place of top
side wire outlet
Cutting place of left
side wire outle t
Cutting place of rig h
t
side wire outle t
• For shielded wiring, please refer to the picture below.
Embedded switch
box wiring
Wiring
hole
Wiring through the wall
Wall hole and wiring hol e

CLIVET ID2-XY 35M Specifications

General

Cooling Capacity	3.5 kW
Refrigerant Type	R32
Outdoor Unit Dimensions (HxWxD)	550x700x275 mm
Indoor Unit Weight	9 kg
Power Supply	220-240 V / 50 Hz

Summary

Specifications

General Specifications

Provides comprehensive technical specifications for various unit models.

Electrical Wiring Diagrams

Capacity Tables

Lists cooling and heating performance data across various conditions.

Electrical Characteristics

Installation

Location Selection

Indoor Unit Installation

Provides detailed instructions for installing the indoor unit.

Outdoor Unit Installation

Details the process for installing the outdoor unit, including mounting.

Drainage Pipe Installation

Explains the principles and procedures for installing drainage pipes.

Refrigerant Pipe Installation

Covers maximum pipe length, drop height, and connection procedures.

Vacuum Drying and Leakage Checking

Outlines the process for vacuum drying and leak testing the system.

Additional Refrigerant Charge

Details the procedure for adding refrigerant based on pipe size and length.

Engineering of Electrical Wiring

Test Operation

Details the steps for performing post-installation tests on the unit.