5
General Details
– Install the electrical cables making sure that they are not taut. Otherwise, they could break or overheat
causing smoke or fire.
– The cables must be arranged so that the control board cover can close properly. If the control board cover
is not closed properly, corrosion may occur and the connection points on the terminals may become hot,
ignite or cause electric shock.
– Always disconnect all power supply circuits before touching the terminals for any reason.
– It is advisable to install a Class B or F differential magnetothermic circuit breaker on the power supply line
of the appliance.
– For electrical work, comply with the provisions of the national electrical code, local regulations, current
regulations and the requirements contained in the installation manual. It is necessary to use an independent
circuit and a single power outlet. Do not connect other appliances to the same electrical outlet. Insufficient
electrical capacity or faulty electrical installation may cause risk of electric shock or fire.
– Incorporate in the wiring an omnipolar isolator switch with a separation distance of at least 3mm between all
poles and a residual current device (RCD) with a value greater than 10mA. Observe the domestic regulations.
– Replace the fuses only with others of the same value and technical characteristics.
– Install the appliance and its power cables at least one metre away from other electrical equipment in order
to avoid interference or noise.
– The appliance must be stored in such a way as to prevent any mechanical damage.
– Consult a qualified technician for unit repair or maintenance.
– Do not modify or alter the safety or protection devices.
– Do not touch the appliance with wet or damp parts of the body as to do so could lead to electric shock.
– Make sure that the power is disconnected before performing any service or maintenance.
– If you notice any anomalies (e.g. a burning smell), stop the appliance, turn off the power switch and consult
your dealer.
– Make sure that the air inlet and outlet are not blocked as this could trigger the protective device that stops
the appliance.
– This appliance is intended for use on commercial premises by experienced or suitably trained users
– This appliance is designed to cool or heat spaces intended for the presence of human beings. It must not
be used to cool or heat food, plants, animals, machinery, equipment or works of art.
– Install the appliance in such a way that the noise and heat is generates does not disturb people living in the
vicinity and does not affect the growth of animals or plants.
– Read this manual carefully before using the unit to ensure its safe operation.
To Next Page
Loading...
Need help?
General