Need help?Do you have a question about the CLIVET WDH-3 2.220 and is the answer not in the manual?
Specifies the unit's intended purpose and outlines critical safety precautions for operation.
Lists applicable certifications like ISO 9001 and CE marking, with relevant directives.
Identifies danger zones and general risks such as fire, burns, and electrical hazards.
Details risks associated with improper electrical connections, grounding, and component access.
Provides safety data for refrigerant R-134a, including handling, first aid, and fire prevention.
Covers general electrical connection principles and power supply requirements.
Provides guidelines for laying and connecting signal and data lines to avoid interference.
Presents detailed electrical data for various unit sizes and configurations.
Covers initial checks of the unit installation and power supply.
Ensures the refrigerating and water circuits are correctly filled and pressurized.
Verifies tightening of electrical connections, grounding, and phase balance.
Explains the control interface, unit start-up, and basic operation modes.
Details the thermoregulation logic and set-point adjustments.
Describes functions that protect compressors and optimize operation based on system needs.
Instructions for viewing, storing, and deleting alarms, and troubleshooting procedures.
Lists common causes and solutions for high/low pressure and faulty sensor alarms.
Details troubleshooting steps for compressor protection alarms and issues.
Presents technical specifications for cooling, heating, and compressor performance.
Provides data on exchangers, water connections, and operating limits.
To Next Page
General