Need help?Do you have a question about the CLIVET WSAN-XEE 102 and is the answer not in the manual?
General| Model | WSAN-XEE 102 |
|---|---|
| Category | Heat Pump |
| Energy Efficiency Ratio (EER) | 3.2 |
| Refrigerant | R410A |
| Power Supply | 400V / 3Ph / 50Hz |
Highlights areas of potential danger and risks associated with unit handling.
Covers risks related to incorrect installation, site selection, and structural integrity.
Discusses risks like burning smells, contact with hot parts, and unskilled maintenance.
Details risks of shock, fire, and damage due to improper electrical connections.
Covers risks from refrigerant escaping and water leaks or blockages.
Essential checks before initiating the unit's startup sequence.
Verifying refrigerant, water, and electrical systems are correctly set up.
Checking power supply voltage, phase balance, and current absorption.
Explains how to switch between ON/OFF, Cooling, Heating, ECO, and Defrosting.
Details how outlet temperature dictates compressor activation and resource usage.
Explains alarm causes, resets, and differentiates between alarms and pre-alarms.
Identifying causes for high and low pressure alarms during cooling operation.
Troubleshooting steps for faulty probes and pressure transducers.
Troubleshooting common protection trips for compressors, fans, and pumps.
Identifying causes for high and low pressure alarms during heating operation.
Key performance figures for cooling, heating, and compressor specifications.
To Next Page
