10
EN
Technical Data
type volt hz watt
682 220-240 50/60 400
Before the first use
Read these operating instructions
carefully before using the appliance
for the first time.
• Remove all packing parts and possibly stickers, but
not the type plate nor the serial number.
• Clean the bowl and the blades with a damp cloth.
• Place the Multi-Shredder on a dry, level, non-slip surfa-
ce.
EC Label / Safety information
The appliance meets the requirements
of the applicable EC directives.
The appliance is designed
for indoor domestic use only.
ATTENTION! Always unplug
the appliance when not in use
and before cleaning.
• The maximum processing time should not exceed 10
seconds in one go.
• Use the appliance in bursts, and not for more than 60
seconds between breaks. Leave the appliance to cool
down for 2-3 minutes once this time is over.
• Do not put any hot food in the bowl. Let the food cool
down somewhat.
• Do not pour any liquids into the bowl.
• Do not shred any extremely hard food or ice cubes.
This can damage the appliance.
Set-up
• Carefully place the middle and upper blades onto the
lower one and turn the latter anticlockwise until the
blades engage.
CAUTION!
The blades are very sharp! Only ever
touch them on the plastic part.
Danger of injury!
• Place the plastic hubs of the blades onto the shaft in
the middle of the glass bowl.
• The three-piece blade set can also be operated wit-
hout the two upper blades. However, the best results
are obtained when all 3 blades are used.
• Cut the food into small pieces and put it in the glass bowl.
• Fill the bowl to the maximum level of the top edge of
the blade set only.
• Put the lid on the bowl.
• Now you can put the motor unit on the lid and turn it
gently so that it engages.
• Plug the plug into a socket.
• Hold the motor unit firmly in one hand and press the
start button with the other to operate the appliance.
• Note! If the motor unit is not correctly engaged, the
appliance will not start.
TIP
Many types of food are best shredded in short
bursts. Additionally, interrupt operation regularly
for a short time. In the pauses, you can check to
see if the desired degree of shredding
has already been reached.
Observe the maximum running times.
• Once the desired degree of shredding has been rea-
ched, wait for a moment until the blades have come
to a complete standstill.
• Pull the power plug from the socket.
• Take off the motor unit and the lid.
• Carefully take the blade set out of the glass bowl by
the plastic.
• You can now take the shredded food out of the bowl.
Quantities and processing time
Some of our recommendations are listed below:
Food Amount Time
Onions 400 g 10 s
Meat 350 g 5 s
Apples 350 g 15 x 1 s
Broccoli 350 g 15 x 1 s
To Next Page
Loading...