MACRO KEYS
Macros can be recorded at any time (without software) via on
board commands. The keyboard supports a maximum of 16 key
combinations per macro.
The macro functions: Select All / Copy / Paste / Cut are
preprogrammed into the 4 macro M-keys (B).
To assign a new macro function, follow these steps:
1) Press the Fn key (C) + any single macro M-key (B) to start
recording.
2) The “M” LED (A) will flash and the new key combination is
ready to be recorded. Enter a new macro key combination.
3) Press the Fn key (C) + the same macro M-key (B) again
to save the recording. The “M” LED (A) will flash 3 times
indicating the macro was successfully saved.
To clear all custom macros
and restore factory
settings, press the Fn key
(C) + “Esc” key and hold
for 3 seconds.
To Next Page
Loading...