Cloudyx CL-99WB - Note on Wiring Extension; Power Input; Audio Output; ADC Button Extension

Shenzhen Cloudecho Audio Co., Ltd.
16
9. Note on wiring extension
9.1 Power Input
 The power input voltage cannot be lower than 4.8V, not higher than 5.5V
 The input current cannot be lower than 1000mA
9.2 Audio output
 AUX OUT is recommended to use shielded wire
 I2S OUT is recommended to use a wire harness, do not use scattered
single wires, and the shorter the wiring, the better
 SPDIF OUT can be connected to optical fiber or coaxial interface, but you
need to pay attention to the properties of the terminal
9.3 ADC button extension
 ADC extension without external pull-up
 ADC extension lead should not be too long, so as not to cause excessive
error of the ADC value
 Extend the resistance value of ADC, please design strictly according to the
reference circuit diagram
9.4 LED extension
 LED extension port can only drive LEDs within 5mA, please pay attention
when selecting LED
 If you need to drive a larger current LED, please add an external MOS tube
to drive
9.5 HDMI Input
 The HDMI CEC line is a high-frequency communication port, which will
frequently send and receive data, and is a source of radiated interference.
It is easy to cause radiated interference to the ARC signal channel and
analog audio channel. When connecting externally, please separate the
CEC line with a ground wire.