Shenzhen Cloudecho Audio Co., Ltd.
4.2 Debug Tool permanently modify the device name
4.2.1 Use APP to view device IP
Check the device IP address through the Audio System APP (see below)
4.2.2 Use Debug Tool to modify the device name
The PC and the device are connected under the same LAN, open the Debug
Tool, enter the IP to connect to the device, and modify the device name by
sending the command, the command: AXX+SET+SID device name&, "device
name" is the target name, and ends with "&", as shown in the following pictures
After sending, the device will automatically restore the factory settings and
write the configuration. Shut down, power off, and restore the factory settings
will not be reset and modified.
To Next Page
Loading...