3. POI Device Installation Instructions
Do not connect non-approved cardholder data capture devices.
The P2PE solution is approved to include specific PCI-approved POI devices. Only these devices denoted
above in table 2.1 are allowed for cardholder data capture.
If a merchant’s PCI-approved POI device is connected to a data capture mechanism that is not PCI approved,
(for example, if a PCI-approved SCR was connected to a keypad that was not PCI-approved):
▪ The use of such mechanisms to collect PCI payment-card data could mean that more PCI DSS
requirements are now applicable for the merchant.
▪ Only P2PE approved capture mechanisms as designated on PCI’s list of Validated P2PE Solutions and
in the PIM can be used.
Do not change or attempt to change device configurations or settings.
Changing or attempting to change device configurations or settings will invalidate the
PCI-approved P2PE solution in its entirety. Examples include, but are not limited to:
▪ Attempting to enable any device interfaces or data-capture mechanisms that were
disabled on the P2PE solution POI device
▪ Attempting to alter security configurations or authentication controls
▪ Physically opening the device
▪ Attempting to install applications onto the device
3.1
Installation and connection instructions
Activate & Connect your Clover Mobile
P2PE Implementation Manual for PCI P2PE v2.0 Clover Network, Inc. April 2018
© 2018 Clover Network, Inc. All Rights Reserved. Page 6
To Next Page
Loading...
Need help?
General
