Why does my Club Car Golf Cars vehicle pull to one side?
Your Club Car Golf Cars vehicle may pull to one side due to several reasons: * Incorrect or distorted brake pads. * Grease or brake fluid on the brake pads. * Scored or warped brake disc. * Water on the brakes. * Sticking caliper piston.
What to do if my Club Car Golf Cars brake pedal feels springy or spongy?
If the brake pedal on your Club Car Golf Cars feels soft, springy, or spongy when pressed, it could be due to: * Cracked or thin disc: Consider replacing the brake discs. * Poor quality brake fluid or water in fluid: Purge the hydraulic fluid and refill with approved DOT 5 (silicone) brake fluid. * Weak (bulging) brake hoses that expand under pressure: Check the master cylinder, brake lines, and hoses for leaks or bulges. Replace any damaged parts. * Air in the hydraulic system.
How to fix a low brake pedal on Club Car Golf Cars?
If the pedal on your Club Car Golf Cars goes to the floor, it may be due to: * Excessive clearance between the disc and brake pads. * A leak in the hydraulic system: Check the master cylinder, brake lines and hoses for leaks. Replace all damaged parts and bleed brake system. * Air in the hydraulic system. * A weak (bulging) brake line: Replace the worn hose. * An improperly adjusted master cylinder push rod.
Why is excessive pedal pressure required to stop my Club Car Golf Cars?
If excessive pedal pressure is required to stop your Club Car Golf Cars vehicle, it could be due to: * Grease or brake fluid on the brake discs or pads: Replace the hub or axle seal and replace the brake pads. * Glazed brake pads: Replace the brake pads. * Damaged or distorted brake pads: Replace the brake pads. * Clogged hydraulic lines: Replace brake lines as required. * Frozen master cylinder piston or bent rod: Replace master cylinder.
What causes pulsating brake pedal in Club Car Golf Cars?
A pulsating brake pedal in your Club Car Golf Cars can be caused by: * Warped or worn brake discs: Replace the brake discs. * Bent wheel: Replace the wheel. * Worn or damaged wheel bearings: Replace bearings.
Why is there noise and chatter when I apply the brakes on my Club Car Golf Cars?
Clicking or scraping sounds upon brake application in your Club Car Golf Cars can be caused by: * Bent, damaged, or incorrect brake pads: Replace the brake pads. * Worn brake pads: Replace the brake pads. * Foreign material embedded in brake pads: Replace the brake pads. * Brake discs are cracked or scored: Replace the brake discs.
What causes all brakes to drag on a Club Car Golf Cars?
If all brakes drag on your Club Car Golf Cars, it may be due to: * Binding brake pedal: Replace bushings and adjust. Also replace any bent or damaged components. * Soft or swollen rubber parts caused by incorrect or contaminated brake fluid: Replace master cylinder.
What causes decreasing brake pedal travel in Club Car Golf Cars?
Decreasing brake pedal travel in your Club Car Golf Cars can be caused by: * Sticking caliper piston: Replace the caliper.
What causes rear brakes to drag on a Club Car Golf Cars?
If the rear brakes drag on your Club Car Golf Cars, it could be due to: * Binding park brake cables: Adjust or replace cables. * Improper brake adjustment.
What causes over-aggressive braking in Club Car Golf Cars?
Over-aggressive braking in Club Car Golf Cars can be caused by: * Incorrect or distorted brake pads: Replace the brake pads.
General| Payload Capacity | 1, 500 lbs |
|---|---|
| Vehicle Load Capacity | 1, 500 lb (680 kg) |
| Engine Type | 4-cycle |
| Seating Capacity | 2 |
| Cargo Bed Capacity | 1, 000 lbs |
| Wheels | Steel |
| Standard Features | Headlights, Taillights, Brake Lights, Horn |
To Next Page
