Club Car TURF 272 User Manual (English)

Other manuals for Club Car TURF 272

Questions and Answers:

K
Kathleen HamiltonSep 6, 2025
Why is only one brake dragging on my Club Car Golf Cars?
- A
  andersondanielSep 6, 2025
  If one brake is dragging on your Club Car Golf Cars, several issues could be responsible. It may be due to weak or broken brake shoe return springs, requiring their replacement. Improper brake shoe adjustment can also cause this, necessitating adjustment of the shoes and repair of the brake shoe adjusters if needed. Sticking wheel cylinder pistons should be addressed by replacing the wheel cylinder. Swollen wheel cylinder cups also require wheel cylinder replacement and purging of the hydraulic system. Bent or distorted brake shoes should be replaced. Loose or worn front wheel bearings should be adjusted or replaced. Finally, a damaged brake line or hydraulic line should be replaced as required.
K
Kristin LeeAug 23, 2025
What to do if Club Car Golf Cars pulls to one side when braking?
- C
  Christina BrownAug 25, 2025
  If you notice your Club Car Golf Cars pulling to one side when braking, several issues could be the cause. It might be due to incorrect or distorted brake shoes, which would need replacement. Grease or brake fluid on the brake shoe linings can also cause this, requiring replacement of the hub, axle seal, or wheel cylinder along with the brake shoes. A loose or distorted brake cluster backing plate should be tightened or replaced. Scored or warped brake drums should also be replaced. If there's water on the brake shoe linings, applying the brakes several times to dry them may resolve the issue. A sticking wheel cylinder piston requires replacement of the wheel cylinder. Lastly, faulty suspension parts can also lead to pulling, so inspect the steering, front, and rear suspension.
S
Shannon BrayAug 25, 2025
Why is the brake pedal spongy on my Club Car Golf Cars?
- J
  Joan LunaAug 26, 2025
  If the brake pedal on your Club Car Golf Cars feels soft, springy, or spongy when you press it, several factors could be responsible. The brake shoes might be bent or distorted, in which case they should be replaced. The brake drums could be cracked or thin, requiring replacement. Using poor quality brake fluid with a low boiling point can also cause this issue; if this is the case, purge the hydraulic fluid and replace it with approved DOT 5 (silicone) brake fluid. Weak brake hoses that expand under pressure can also create this sensation, so inspect the master cylinder, brake lines, and hoses for leaks or bulges and replace any damaged parts. Finally, air in the hydraulic system can lead to a spongy pedal feel, so ensure the system is properly bled.
H
Heather LunaAug 27, 2025
Why is my Club Car Golf Cars braking too aggressively?
- G
  gabriellagarciaAug 27, 2025
  If you're experiencing over-aggressive braking with your Club Car Golf Cars, it could be due to several factors. The brake shoes may be incorrect or distorted, requiring replacement. Grease or brake fluid on the brake shoe linings can also cause this, necessitating replacement of the hub, axle seal, or wheel brake cylinder along with the brake shoes. A loose or distorted brake backing plate should be tightened or replaced. Scored or warped brake drums should be replaced. A corroded master cylinder bore requires replacement of the master cylinder. Lastly, binding brake pedal linkage should be lubricated and adjusted.
B
Bruce BurnsAug 27, 2025
Why does my Club Car Golf Cars have a hard brake pedal?
- M
  millerjillAug 27, 2025
  A hard pedal on your Club Car Golf Cars, requiring excessive pressure to stop, can stem from several causes. Brake fade can lead to this issue, suggesting the brake shoes need replacement. Grease or brake fluid on the brake shoe linings can also cause a hard pedal, necessitating replacement of the hub or axle seal along with the brake shoes. Glazed brake shoe linings are another potential cause, also requiring brake shoe replacement.
W
William WongAug 28, 2025
What causes a hard brake pedal on Club Car Golf Cars?
- L
  lhernandezAug 29, 2025
  A hard brake pedal on your Club Car Golf Cars can be caused by several issues: damaged or distorted brake shoes (replace the brake shoes), scored or barrel-shaped brake shoe drums (replace the brake drums), clogged master cylinder lines or hoses (replace brake lines or hoses), or a frozen master cylinder piston (replace the master cylinder).
D
Diane OsborneSep 12, 2025
What to do if my Club Car Utility Vehicle has over-aggressive braking?
- G
  Garrett CrawfordSep 12, 2025
  Over-aggressive braking in your Club Car Utility Vehicle may be due to incorrect or distorted brake shoes, grease or brake fluid on the brake shoe linings, a loose or distorted brake backing plate, scored or warped brake drums, a corroded master cylinder bore, or binding brake pedal linkage. Replace the brake shoes, hub, axle seal, or wheel brake cylinder if there is grease or brake fluid on the linings. Tighten or replace the back plate and/or hardware if it is loose or distorted. Replace the brake drums if they are scored or warped. Replace the master cylinder if the bore is corroded. Lubricate and adjust the brake pedal linkage if it is binding.
K
Kimberly RogersSep 14, 2025
Why does my Club Car Utility Vehicle pull to one side when braking?
- C
  cooknicholasSep 14, 2025
  Your Club Car Utility Vehicle may pull to one side when braking due to incorrect or distorted brake shoes, grease or brake fluid on the brake shoe linings, a loose or distorted brake cluster backing plate, scored or warped brake drums, water on the brake shoe linings, a sticking wheel cylinder piston, or faulty suspension parts. If there is water on the brake shoe linings, apply the brakes several times to dry them. If the backing plate is loose or distorted, tighten or replace the backing plate and/ or hardware. If the wheel cylinder piston is sticking, replace the wheel cylinder.
A
Andrew VasquezSep 5, 2025
What to do if brake pedal travel is decreasing on Club Car Golf Cars?
- S
  Shelly GrantSep 5, 2025
  Decreasing brake pedal travel in your Club Car Golf Cars can be caused by a sticking wheel cylinder piston (replace the wheel cylinder), overly adjusted brake adjusters (adjust brake adjusters), or an improperly adjusted park brake (adjust park brake).
A
aaronjohnsonSep 2, 2025
Why are the rear brakes dragging on my Club Car Golf Cars?
- M
  Madison StanleySep 3, 2025
  If the rear brakes are dragging on your Club Car Golf Cars, it could be due to binding park brake cables, which would require adjustment or replacement, followed by adjustment. Alternatively, improper brake adjustment can cause this issue, requiring adjustment of the shoes and repair of the brake shoe adjusters if necessary.