To Next Page

To Previous Page

FIG. 32 FIG. 33

To secure the wake boards to the wake board racks, starting at the top of the

brace plate, insert the end of shock cord assembly opposite the handle into the

two machined slots as show in Fig. 33. Pull the shock cord over the boards and

up into the two machine slots at the bottom of the brace plate (Fig. 34). Insert into

these two slots as shown in Fig. 35.

FIG. 34 FIG. 35

STORAGE

The tower can be tilted forward or backwards for storage if desired. Remember,

the wire cable must go through one of the pivot clevis feet so that the wires will

not have to be disconnected. To tilt forward, remove the two 3/8”-16 X1-1/2”

bolts from the clevis pins at the back and tilt forward as shown in Fig. 28. To tilt

toward the back, remove the two 3/8”-16 X 1-1/2” bolts from the clevis feet at the

front as shown in Fig. 29. Or remove the tower completely by taking all four of the

clevis pins from the clevis feet.

Questions and Answers:

Need help?

Do you have a question about the CMC Typhoon Tower and is the answer not in the manual?

CMC Typhoon Tower Specifications

General