CNCDIY MACH 3 - User Manual


Initial configuration:
Modbus protocol used to communicate and Mach3.Using RS2332 and PC connection, USB to take
power.Mach3modbusprovidesaveryfriendlyinterface,souseModSelectronichandwheelwithout
havingtoinstalladditionaldrivers.
The ModS serial (COM port) and the computer serial port (COM port) connection, and tighten the
screws.USBplugandtheModScomputerconnections.RunMach3.














CNC CONTROL HANDLEWHEEL USB
User Manual
www.ekt2 .com
Electronics
Katrangi
Trading

Summary

Initial Configuration

Engine Configuration Ports and Pins

Encoder and MPG Setup

Configure Encoder and MPG settings within the Mach3 software interface.

General Logic Configuration

Startup Modals Configuration

Configure startup modals and initialization strings for Mach3.

Motion Mode Settings

Set motion mode, distance mode, and active plane of movement.

Shuttle Wheel and Jog Settings

Adjust shuttle wheel acceleration and jog increment settings.

Run Macro Pump Control

Enable or disable the 'Run Macro Pump' function in Mach3.

CNCDIY MACH 3 Specifications